B2764 Short to GND in Intrusion Sensor Signal Circuit
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
- The intrusion sensor (theft warning ultrasonic sensor) conducts self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).
If a malfunction is detected in the ISIF line, the certification ECU (smart key ECU assembly) stores this DTC.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B2764 |
After normal/trouble signal is output from intrusion sensor as result of self-diagnosis, following malfunctions are detected:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK INTRUSION SENSOR (IOUT) |
Using an oscilloscope, check the waveform.


Text in Illustration *a
Component with harness connected
(Map Light Assembly)
*b
IOUT Initial Signal
*c
IOUT Initial Response
*d
Approximately 1.0 seconds
*e
Initial Diagnosis
*f
Approximately 1.0 to 1.6 seconds
*g
Approximately 0.05 seconds
*h
Approximately 5.5 seconds
*i
Disarmed State
*j
Arming Preparation State
Measurement Condition Tester Connection
Content
Tester Connection
R7-12 (IOUT) - Body ground
Tool Setting
2 V/DIV., 100 ms./DIV.
Condition
Theft deterrent system is set (system changes from disarmed state to arming preparation state)
- HINT:
- If the intrusion sensor is normal, an initial response is output in response to the HI input from the certification ECU (smart key ECU assembly).
- If the waveform output remains LO, there may be a problem with the certification ECU (smart key ECU assembly), as there is no input from the certification ECU (smart key ECU assembly).
- If the intrusion sensor is normal, an initial response is output in response to the HI input from the certification ECU (smart key ECU assembly).
- OK:
- The waveform displays properly (HI is 6.5 V or higher and LO is below 1 V).
|
|
||||
| OK | ||
| ||
| 2. CHECK INTRUSION SENSOR (IOUT) |
Disconnect the map light assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
R7-12 (IOUT) - R7-3 (GND5)
Immediately after theft deterrent system set
Result Result
Proceed to
IOUT voltage is below 1 V when theft deterrent system is set
A
IOUT voltage is 6.5 V or higher when theft deterrent system is set
B
- HINT:
- With connector R7 of the map light assembly disconnected, measure the voltage at IOUT when the theft deterrent system is set.
|
|
||||
| A | |
| 3. CHECK HARNESS AND CONNECTOR (MAP LIGHT - CERTIFICATION ECU [SMART KEY ECU ASSEMBLY]) |
Disconnect the R7 map light assembly connector.
Disconnect the E30 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R7-12 (IOUT) - E30-4 (IOUT)
Always
Below 1 Ω
R7-12 (IOUT) or E30-4 (IOUT) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
