ON-VEHICLE INSPECTION
Inspection · Vehicles built from Sep 2011
| INSPECT FOR COOLANT LEAK |
- HINT:
- Before performing this inspection, check that there is no coolant leaking from any parts other than the water pump. If there are leaks, inspect those areas.
- Perform this inspection when the engine is cold.
- Before performing this inspection, check that there is no coolant leaking from any parts other than the water pump. If there are leaks, inspect those areas.
Visually inspect the engine compartment for the following conditions.
There is a large amount of coolant in the engine compartment or on the underside of the hood near the fan and generator V belt.
Liquid coolant is dripping from around the water pump.
The coolant level in the reservoir is below the L line and there are traces of leakage around the water pump.
- HINT:
- If any of the above conditions exist, replace the water pump assembly.
- If none of the above conditions exist, perform the following inspection (inspection of the area around the water pump).
- If any of the above conditions exist, replace the water pump assembly.
Inspect the area around the water pump.
- HINT:
- Check for deposits around the drain hole of the water pump.
Press the thin paper towel against the coolant (solid matter) adhering to the drain hole or the edge of the drain hole, and check the condition of the thin paper towel.

Text in Illustration *1
Water Pump Pulley
*2
Drain Hole
- HINT:
- If the thin paper towel is wet, replace the water pump assembly.
- If the thin paper towel is dry, thoroughly clean the area around the water pump.
- If the thin paper towel is wet, replace the water pump assembly.
| INSPECT WATER PUMP ASSEMBLY |
Remove the fan and generator V belt (Click here).
Turn the pulley and check that the water pump bearing moves smoothly and quietly.

If necessary, replace the water pump.
Install the fan and generator V belt (Click here).
