Remove the 32 valve rocker arms from the cylinder heads.
HINT:
Arrange the removed parts in the correct order.
4.
REMOVE VALVE LASH ADJUSTER ASSEMBLY
Remove the 32 valve lash adjusters from the cylinder heads.
HINT:
Arrange the removed parts in the correct order.
5.
REMOVE VALVE STEM CAP
Remove the 32 valve stem caps from the cylinder heads.
HINT:
Arrange the removed parts in the correct order.
6.
REMOVE CYLINDER HEAD SUB-ASSEMBLY LH
Uniformly loosen and remove the 2 bolts in the sequence shown in the illustration.
Using a 10 mm bi-hexagon wrench, uniformly loosen the 10 cylinder head bolts in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.
NOTICE:
Be careful not to drop washers into the cylinder head.
Head warpage or cracking could result from removing bolts in an incorrect order.
HINT:
Be sure to arrange the removed parts for each installation position separately.
Remove the cylinder head and gasket.
7.
REMOVE CYLINDER HEAD SUB-ASSEMBLY RH
Uniformly loosen and remove the 2 bolts in the sequence shown in the illustration.
Using a 10 mm bi-hexagon wrench, uniformly loosen the 10 cylinder head bolts in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.
NOTICE:
Be careful not to drop washers into the cylinder head.
Head warpage or cracking could result from removing bolts in an incorrect order.
HINT:
Be sure to arrange the removed parts for each installation position separately.