2011-2013 Land Cruiser · Service Manual Power Source / Network

B2789 No Response from ID BOX

Diagnostic trouble codes · Vehicles built from Sep 2011

DESCRIPTION

This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) stops for 10 seconds or more.
DTC Code
DTC Detection Condition
Trouble Area
B2789
No communication between the certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) for 10 seconds or more.
  1. ID code box (immobiliser code ECU)
  2. Certification ECU (smart key ECU assembly)
  3. Harness or connector

WIRING DIAGRAM

B173719E20

INSPECTION PROCEDURE

NOTICE:
When using the intelligent tester with the ignition switch off to troubleshoot:
Connect the intelligent tester to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.

HINT:
DTC B2785 is stored when the communication between the ID code box (immobiliser code ECU) and certification ECU (smart key ECU assembly) stops.


1. CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


2. CHECK FOR DTC
  1. Recheck for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC B2789 is output
    A
    DTC B2789 is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ID CODE BOX)
E156407E01
  1. Disconnect the E29 ECU connector.

  1. Disconnect the E28 box connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E29-10 (LIN) - E28-3 (LIN1)
    Always
    Below 1 Ω
    E29-10 (LIN) or E28-3 (LIN1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY AND BODY GROUND)

  1. B157071E03
    Disconnect the E28 box connector.

  1. Measure the resistance and voltage according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E28-8 (GND) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E28-1 (+B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. REPLACE ID CODE BOX (IMMOBILISER CODE ECU)
  1. Temporarily replace the ID code box (immobiliser code ECU) with a new or normally functioning one.

  1. Clear the DTC (Click here).


NEXT


6. CHECK FOR DTC
  1. Recheck for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC B2789 is output
    A
    DTC B2789 is not output
    B



B
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
A

END (ID CODE BOX IS DEFECTIVE)


← B2786 No Response from Steering Lock ECU (from Jan 2012)Rain Sensor LIN Communication Malfunction (Sep 2011 – Dec 2011) →