B2786 No Response from Steering Lock ECU
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and steering lock actuator (steering lock ECU) stops for 10 seconds or more.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B2786 |
Periodic transmission from the steering lock ECU stops for 10 seconds or more. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When using the intelligent tester with the ignition switch off to troubleshoot:
- Connect the intelligent tester to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.
- HINT:
- DTC B2785 is stored when the communication between the steering lock ECU and certification ECU (smart key ECU assembly) stops.
| 1. CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 2. CHECK FOR DTC |
Recheck for DTCs (Click here).
Result Result
Proceed to
DTC B2786 is output
A
DTC B2786 is not output
B
|
|
||||
| A | |
| 3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - STEERING LOCK ECU) |
![]() ![]() |
Disconnect the E29 and E26 ECU connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E29-10 (LIN) - E26-5 (LIN)
Always
Below 1 Ω
E29-10 (LIN) or E26-5 (LIN) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK STEERING LOCK ACTUATOR (BATTERY VOLTAGE AND BODY GROUND) |
Disconnect the E26 ECU connector.

Measure the resistance and voltage according to the value(s) in the tables below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E26-1 (GND) - Body ground
Always
Below 1 Ω
- Standard Voltage:
Tester Connection
Condition
Specified Condition
E26-7 (B) - Body ground
Always
11 to 14 V
|
|
||||
| OK | |
| 5. REPLACE STEERING LOCK ACTUATOR ASSEMBLY |
Temporarily replace the steering lock actuator with a new or normally functioning one (Click here).
Clear the DTC (Click here).
| NEXT | |
| 6. CHECK FOR DTC |
Recheck for DTCs (Click here).
Result Result
Proceed to
DTC B2786 is not output
A
DTC B2786 is output
B
|
|
||||
| A | ||
| ||

