B1458/58 Passenger Side Air Outlet Damper Control Servo Motor Circuit
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The front air mix damper servo motor (for front passenger side rear air flow) sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the front air mix damper (for front passenger side rear air flow) to any position. As a result, the amount of air that has passed through the evaporator and is passing through the heater core is adjusted, and the temperature of the air blowing toward the rear passenger side is controlled.- HINT:
- Confirm that no mechanical problem is present because this trouble code can be output when either a damper link or damper is mechanically locked.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B1458/58 |
The air mix damper position does not change even if the air conditioning amplifier assembly operates the front air mix damper servo motor. |
|
WIRING DIAGRAM




INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (FRONT AIR MIX DAMPER SERVO MOTOR) |
Use the Data List to check if the servo motor is functioning properly.
Air Conditioner Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Air Mix Servo Targ Pls (F&R P)
Front air mix damper servo motor (for front passenger side rear air flow) target pulse /
Min.: 5, Max.: 33 (for LHD)
Min.: 13, Max.: 41 (for RHD)
for LHD - MAX COOL: 33 (pulse)
- MAX HOT: 5 (pulse)
- MAX COOL: 13 (pulse)
- MAX HOT: 41 (pulse)
-
- OK:
- The display is as specified in the normal condition.
- MAX COOL: 33 (pulse)
|
|
||||
| OK | ||
| ||
| 2. CHECK FRONT AIR MIX DAMPER SERVO MOTOR (OPERATION) |
for LHD:
Replace the front air mix damper servo motor (for front passenger side rear air flow) (Click here).
for RHD:
Replace the front air mix damper servo motor (for front passenger side rear air flow) (Click here).
- HINT:
- Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one.
| NEXT | |
| 3. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC B1458 is not output.
Result Result
Proceed to
OK (for LHD)
A
OK (for RHD)
B
NG (for LHD)
C
NG (for RHD)
D
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
