2011-2013 Land Cruiser · Service Manual Vehicle Interior

B1486/86 Driver Side Air Outlet Damper Control Servo Motor Circuit

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The air outlet damper servo motor (for rear seat mode) sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the air outlet damper to any position, which controls the air outlet changes.

HINT:
Confirm that no mechanical problem is present because this trouble code can be output when either a damper link or damper is mechanically locked.

DTC Code
DTC Detection Condition
Trouble Area
B1486/86
The air outlet damper position does not change even if the air conditioning amplifier assembly operates the air outlet damper servo motor.
  1. Air outlet damper servo motor (for rear seat mode)
  2. Air conditioning harness assembly
  3. Air conditioning amplifier assembly

WIRING DIAGRAM

E161749E18
E161749E19

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (AIR OUTLET DAMPER SERVO MOTOR)
  1. Use the Data List to check if the servo motor is functioning properly.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Outlet Servo Pls (F&R D)
    Air outlet damper servo motor (for rear seat mode) target pulse /
    Min.: 9, Max.: 79
    FACE1: 9 (pulse)
    FACE2: 9 (pulse)
    B/L1: 28 (pulse)
    B/L2: 34 (pulse)
    FOOT-O: 41 (pulse)
    FOOT-D: 41 (pulse)
    FOOT-R: 41 (pulse)
    FOOT-F: 58 (pulse)
    F/D: 67 (pulse)
    DEF: 79 (pulse)
    -

    OK:
    The display is as specified in the normal condition.



NG
Go to step 2
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)

2. CHECK AIR OUTLET DAMPER SERVO MOTOR (OPERATION)
  1. Replace the air outlet damper servo motor (for rear seat mode) (Click here).

    HINT:
    Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one.


NEXT


3. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B1486 is not output.



NG
REPLACE AIR CONDITIONING HARNESS ASSEMBLY (Click here)
OK

REPLACE AIR OUTLET DAMPER SERVO MOTOR (Click here)


← B1468/68 Rear Passenger Side Room Temperature Sensor Circuit (from Jan 2012)B1486/86 Driver Side Air Outlet Damper Control Servo Motor Circuit (from Jan 2012) →