2011-2013 Land Cruiser · Service Manual Vehicle Interior

B1445/45 Passenger Side Cool Air Bypass Damper Control

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The cool air bypass damper servo motor sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the cool air bypass damper to any position. As a result, when the air conditioner is operating, the temperature of the air blowing toward the head area is controlled.

HINT:
Confirm that no mechanical problem is present because this trouble code can be output when either a damper link or damper is mechanically locked.

DTC Code
DTC Detection Condition
Trouble Area
B1445/45
The cool air bypass damper position does not change even if the air conditioning amplifier assembly operates the cool air bypass damper servo motor.
  1. Cool air bypass damper servo motor
  2. Air conditioning harness assembly
  3. Air conditioning amplifier assembly

WIRING DIAGRAM

E161749E07
E161749E08

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (COOL AIR BYPASS DAMPER SERVO MOTOR)
  1. Use the Data List to check if the servo motor is functioning properly.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Cool Air Bypass Pulse
    Cool air bypass damper servo motor target pulse /
    Min.: 6, Max.: 57
    Shut: 6 (pulse)
    Open: 57 (pulse)
    -

    OK:
    The display is as specified in the normal condition.



NG
Go to step 2
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)

2. CHECK COOL AIR BYPASS DAMPER SERVO MOTOR (OPERATION)
  1. for LHD:

    1. Replace the cool air bypass damper servo motor (Click here).

  1. for RHD:

    1. Replace the cool air bypass damper servo motor (Click here).

      HINT:
      Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one.


NEXT


3. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B1445 is not output.

    Result 
    Result
    Proceed to
    OK (for LHD)
    A
    OK (for RHD)
    B
    NG (for LHD)
    C
    NG (for RHD)
    D



B
REPLACE COOL AIR BYPASS DAMPER SERVO MOTOR (Click here)

C
REPLACE AIR CONDITIONING HARNESS ASSEMBLY (Click here)

D
REPLACE AIR CONDITIONING HARNESS ASSEMBLY (Click here)
A

REPLACE COOL AIR BYPASS DAMPER SERVO MOTOR (Click here)


← B1443/43 Air Outlet Damper Control Servo Motor Circuit (from Jan 2012)B1445/45 Passenger Side Cool Air Bypass Damper Control (from Jan 2012) →