2011-2013 Land Cruiser · Service Manual Vehicle Interior

Meter Illumination is Always Dark

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

w/ Multi-information Display:
In this circuit, the combination meter assembly receives auto dimmer signals from the main body ECU using the CAN communication lines. When the combination meter assembly receives an auto dimmer signal, it dims the meter illumination. The main body ECU determines whether it is daytime, twilight or nighttime based on the waveform transmitted from the automatic light control sensor. If the main body ECU determines that it is daytime, the ECU does not send auto dimmer signals. Therefore, the meter illumination (warning and indicator lights) will not dim even if the driver accidentally turns the light control switch to the TAIL or HEAD position in the daytime.

HINT:
When the meter illumination does not dim at night, the light control rheostat position is in the TAIL cancel position, or there may be a malfunction in the automatic light control sensor, main body ECU, CAN communication system, wire harness or connector, or combination meter.


WIRING DIAGRAM

E156904E02

INSPECTION PROCEDURE


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    CAN communication system (for LHD) DTC is output
    B
    CAN communication system (for RHD) DTC is output
    C
    Lighting system DTC (B1244) is output
    D



B
Go to CAN COMMUNICATION SYSTEM (Click here)

C
Go to CAN COMMUNICATION SYSTEM (Click here)

D
Go to LIGHTING SYSTEM (Click here)
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (DIMMER SWITCH)
  1. Operate the intelligent tester according to the display and select Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Dimmer Signal
    Illumination dimming operation
    ON or OFF
    -

    OK:
    Meter illumination is dimmed when the dimmer switch is ON.

    HINT:
    Refer to the sensitivity setting in the customization table of the automatic light control system (Click here).



NG
Go to step 3
OK

CHECK LIGHTING SETTING (Click here)

3. REPLACE COMBINATION METER ASSEMBLY
  1. Temporarily replace the combination meter with a new one (Click here).


NEXT


4. CHECK COMBINATION METER ASSEMBLY
  1. Check that the operation of the combination meter returns to normal (Click here).

    OK:
    Operation of combination meter returns to normal.



NG
REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)
OK

END (COMBINATION METER IS DEFECTIVE)


← Meter Illumination is Always Dark (Sep 2011 – Dec 2011)Meter Illumination does not Dim at Night (Sep 2011 – Dec 2011) →