2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Mute Signal Circuit between Radio Receiver and Multi-media Interface ECU

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The multi-media interface ECU sends a mute signal to the radio receiver assembly.
The radio receiver assembly controls the volume according to the mute signal from the multi-media interface ECU.
The mute signal is sent to reduce noise and popping sounds generated when switching modes.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the radio receiver assembly is functioning, no sound, or only an extremely faint sound, can be heard.

WIRING DIAGRAM

E175068E20

INSPECTION PROCEDURE


1. INSPECT RADIO RECEIVER ASSEMBLY

  1. E152226E29
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F55-6 (MUTE) - Body ground
    Engine switch on (ACC), USB audio system is playing → Mode is changing
    Above 2.5 V → Below 0.5 V

    Text in Illustration 
    *1
    Component with harness connected
    (Radio Receiver Assembly)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MULTI-MEDIA INTERFACE ECU)
  1. Disconnect the F55 radio receiver assembly and L40 multi-media interface ECU connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F55-6 (MUTE) - L40-6 (MUTI)
    Always
    Below 1 Ω
    F55-6 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT MULTI-MEDIA INTERFACE ECU

  1. E152226E30
    Reconnect the L40 multi-media interface ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    L40-6 (MUTI) - Body ground
    Engine switch on (ACC)
    Above 2.5 V

    Text in Illustration 
    *1
    Component with harness connected
    (Multi-media Interface ECU)



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

REPLACE RADIO RECEIVER ASSEMBLY (Click here)


← Mute Signal Circuit between Radio Receiver and Multi-media Interface ECU (Sep 2011 – Dec 2011)AVC-LAN Circuit (Sep 2011 – Dec 2011) →