Mute Signal Circuit between Radio Receiver and Multi-media Interface ECU
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The multi-media interface ECU sends a mute signal to the radio receiver assembly.The radio receiver assembly controls the volume according to the mute signal from the multi-media interface ECU.
The mute signal is sent to reduce noise and popping sounds generated when switching modes.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the radio receiver assembly is functioning, no sound, or only an extremely faint sound, can be heard.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT RADIO RECEIVER ASSEMBLY |
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
F55-6 (MUTE) - Body ground
Engine switch on (ACC), USB audio system is playing → Mode is changing
Above 2.5 V → Below 0.5 V
Text in Illustration *1
Component with harness connected
(Radio Receiver Assembly)
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MULTI-MEDIA INTERFACE ECU) |
Disconnect the F55 radio receiver assembly and L40 multi-media interface ECU connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F55-6 (MUTE) - L40-6 (MUTI)
Always
Below 1 Ω
F55-6 (MUTE) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. INSPECT MULTI-MEDIA INTERFACE ECU |
Reconnect the L40 multi-media interface ECU connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
L40-6 (MUTI) - Body ground
Engine switch on (ACC)
Above 2.5 V
Text in Illustration *1
Component with harness connected
(Multi-media Interface ECU)
|
|
||||
| OK | ||
| ||
