Active Control Engine Mount System
Circuit diagnosis · Vehicles built from Jan 2012
DESCRIPTION
The Active Control Engine Mount (ACM) system decreases engine vibration at low engine speed using the VSV for engine mount. The VSV is controlled by a pulse signal transmitted to the VSV from the ECM. The frequency of this pulse signal is matched to the engine speed to decrease engine vibration.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses of circuits related to this system before performing the following inspection procedure.
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
- Inspect the fuses of circuits related to this system before performing the following inspection procedure.
| 1. PERFORM ACTIVE TEST USING GTS |
Warm up the engine.
Connect the GTS to the DLC3.
Move the shift lever to N or P.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the ACM Inhibit.
Hold the top part of the steering wheel, and turn the Active Test from OFF to ON. Check the engine vibration.
- Result:
Engine Vibration
Proceed to
Increases
A
Does not increase
B
|
|
||||
| B | |
| 2. CHECK VACUUM |
Check if the vacuum hose cap is missing, if the hose is damaged, and if the air and vacuum hoses have looseness, disconnection or blockage.
- OK:
- Vacuum hose cap is not missing and hoses are normal.
|
|
||||
| OK | |
| 3. INSPECT VSV FOR ENGINE MOUNT |
Inspect the VSV for engine mount (Click here).
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (VSV FOR ENGINE MOUNT - ECM, EFI NO. 2 FUSE - VSV FOR ENGINE MOUNT) |
Disconnect the VSV for engine mount connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for LHD Tester Connection
Condition
Specified Condition
C81-2 - A38-52 (ACM)
Always
Below 1 Ω
C81-2 or A38-52 (ACM) - Body ground
Always
10 kΩ or higher
for RHD Tester Connection
Condition
Specified Condition
C81-2 - A52-52 (ACM)
Always
Below 1 Ω
C81-2 or A52-52 (ACM) - Body ground
Always
10 kΩ or higher
Remove the EFI NO. 2 fuse from the engine room relay block.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
EFI NO. 2 fuse (2) - C81-1
Always
Below 1 Ω
|
|
||||
| OK | |
| 5. INSPECT ENGINE MOUNTING INSULATOR FRONT |
Inspect the engine mounting insulator front (Click here).
|
|
||||
| OK | ||
| ||
