2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Front Fog Light Circuit

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The main body ECU receives a front fog light switch information signal from the light control switch (front fog switch), and illuminates the front fog lights.

WIRING DIAGRAM

E246617E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (FRONT FOG LIGHT)
  1. Using the intelligent tester, perform the Active Test (Click here).

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Front Fog Light Relay
    Front fog light
    ON or OFF
    -

    OK:
    Fog light turns on/turns off.



NG
Go to step 2
OK

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

2. INSPECT FOG LIGHT RELAY (FR FOG)
E121182E13
  1. Remove the fog light relay from the engine room relay block, junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω



NG
REPLACE FOG LIGHT RELAY (FR FOG)
OK


3. CHECK HARNESS AND CONNECTOR (FOG LIGHT RELAY [FR FOG] - BATTERY)
E160901E03
  1. Remove the fog light relay from the engine room relay block, junction block.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Fog light relay terminal 2 - Body ground
    Light control switch tail
    11 to 14 V
    Fog light relay terminal 5 - Body ground
    Always

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Fog Light Relay [FR FOG])



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (FOG LIGHT RELAY [FR FOG] - MAIN BODY ECU [COWL SIDE JUNCTION BLOCK LH])
  1. Remove the fog light relay from the engine room relay block, junction block.

  1. Disconnect the E1 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Fog light relay terminal 1 - E1-4 (FFGO)
    Always
    Below 1 Ω
    Fog light relay terminal 1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Front Fog Light Circuit (Sep 2011 – Dec 2011)Rear Fog Light Circuit (Sep 2011 – Dec 2011) →