2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P060A Internal Control Module Monitoring Processor Performance

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The main CPU and sub CPU of the ECM perform data communication with each other. The main CPU monitors the communication signals from the sub CPU. When the signal malfunctions below are detected, a DTC is stored.
DTC Code
DTC Detection Condition
Trouble Area
P060A
An ECM sub CPU error.
ECM

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.


1. CHECK DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the ignition switch to ON.

  1. Check for DTC.

    OK:
    P060A is not output.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← P0606 ECM / PCM Processor (from Jan 2012)P060A Internal Control Module Monitoring Processor Performance (from Jan 2012) →