P060A Internal Control Module Monitoring Processor Performance
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, a DTC is stored.| DTC Code |
DTC Detection Condition |
Trouble Area |
| P060A |
When a condition below is met:
|
ECM |
INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
| 1. CHECK DTC |
Clear DTC (Click here).
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the engine switch on (IG).
Check for DTC.
- OK:
- P060A is not output.
|
|
||||
| OK | ||
| ||
