2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P060B Internal Control Module A/D Processing Performance

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This DTC is stored when a communication error occurs in the ECM.
DTC Code
DTC Detection Condition
Trouble Area
P060B
An ECM main CPU communication error.
ECM

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.


1. CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the engine switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the engine switch on (IG).

  1. Check for DTC.

    OK:
    P060B is not output.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← P060A Internal Control Module Monitoring Processor Performance (Sep 2011 – Dec 2011)P060D Internal Control Module Accelerator Pedal Position Performance (Sep 2011 – Dec 2011) →