2011-2013 Land Cruiser · Service Manual Vehicle Interior

Voltage Meter Malfunction

Circuit diagnosis · Vehicles built from Sep 2011

DESCRIPTION

The voltmeter indicates the voltage applied to the IG+ terminal of the combination meter.

WIRING DIAGRAM

E146354E04

INSPECTION PROCEDURE


1. INSPECT FUSE (MET)
  1. Remove the MET fuse from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    MET fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VOLTMETER)
  1. Operate the intelligent tester according to the display and select Active Test (Click here).

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Volt meter Operation
    Voltmeter
    0, 3, 6, 9, 12, 15, or 18
    Perform the test with the vehicle stopped and engine idling.

    OK:
    Needle indication is normal.

    Result 
    Result
    Proceed to
    OK
    A
    NG (w/ Multi-information Display)
    B
    NG (w/o Multi-information Display)
    C



B
REPLACE COMBINATION METER ASSEMBLY (Click here)

C
REPLACE COMBINATION METER ASSEMBLY (Click here)
A


3. CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND)
E157223E01
  1. Disconnect the E7 meter connector.

  1. Measure the resistance and voltage according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E7-15 (ET) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E7-18 (IG+)
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V

    Result 
    Result
    Proceed to
    NG
    A
    OK (w/ Multi-information Display)
    B
    OK (w/o Multi-information Display)
    C



B
REPLACE COMBINATION METER ASSEMBLY (Click here)

C
REPLACE COMBINATION METER ASSEMBLY (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR


← Oil Pressure Gauge Malfunction (from Jan 2012)PARTS LOCATION (from Sep 2011) →