2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE DISABLE AUTO TILT AWAY FUNCTION
  1. for Power Tilt and Power Telescopic Steering Column:

    1. Disable the Autoaway/Return function by changing the customize parameter (Click here).

      NOTICE:
      Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      HINT:
      Performing the above operation causes the Autoaway/Return function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the engine switch off .


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

  1. E154744E01
    Place protective tape as shown in the illustration.

  1. Using a moulding remover, detach the 3 claws and remove the panel garnish.


4. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

  1. E155426E01
    Place protective tape as shown in the illustration.

  1. Using a moulding remover, detach the 7 claws and remove the panel cushion.


5. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
  1. w/ Entry and Start System:
    (Click here)

  1. w/o Entry and Start System:
    (Click here)


6. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

  1. E154741E01
    Place protective tape as shown in the illustration.

  1. Using a moulding remover, detach the 2 claws and remove the panel garnish.


7. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
  1. for Manual Tilt and Manual Telescopic Steering Column:

    1. Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.

  1. E154839
    Detach the 4 claws.

  1. E154840
    Detach the 9 claws and remove the finish panel.


8. REMOVE COMBINATION METER ASSEMBLY

  1. E155399
    Remove the 4 screws.

  1. E155400
    Disconnect the connectors, and remove the combination meter by pulling it up in the direction of the arrow in the illustration.

← COMPONENTS (from Sep 2011)REMOVAL (from Jan 2012) →