2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE FRONT BUMPER COVER
  1. for Standard:
    Remove the front bumper cover (Click here).

  1. w/ Winch:
    Remove the front bumper cover (Click here).


2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.


3. REMOVE AIR CONDITIONER PRESSURE SENSOR

E156981
  1. Disconnect the connector.

  1. Remove the pressure sensor.

  1. Remove O-ring from the pressure sensor.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

← COMPONENTS (from Sep 2011)REMOVAL (from Jan 2012) →