2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT NO. 1 EMISSION CONTROL VALVE SET

  1. A224402E02
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 5
    20°C (68°F)
    4.5 to 5.5 Ω
    1 - Body ground
    Always
    1 MΩ or higher
    5 - Body ground

    Text in Illustration 
    *a
    Component without harness connected
    (No. 1 Emission Control Valve Set)

    HINT:
    1. When measuring the resistance, do not touch terminals 2, 3 or 4.
    2. When measuring the resistance, make sure that the surface temperature of the No. 1 emission control valve set is 20°C (68°F).

    If the result is not as specified, replace the No. 1 emission control valve set.

  1. A224403E02
    Check the operation of the No. 1 emission control valve set.

    1. Check that air does not flow from port A to port B.

      Text in Illustration 
      *1
      Port A
      *2
      Port B
      V100135
      Air

      NOTICE:
      Make sure the applied pressure is 30 kPa (0.3 kgf/cm2, 4.4 psi) or less.

      If the result is not as specified, replace the No. 1 emission control valve set.

    2. A224404E02
      Apply battery voltage across terminals 1 and 5.

      NOTICE:
      When applying voltage, do not touch terminals 2, 3 or 4.

    3. Check that air flows from port A to port B.

      Text in Illustration 
      *1
      Port A
      *2
      Port B
      *a
      Component without harness connected
      (No. 1 Emission Control Valve Set)
      V100135
      Air
      If the result is not as specified, replace the No. 1 emission control valve set.

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →