2011-2013 Land Cruiser · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built from Sep 2011


1. DRAIN DIFFERENTIAL OIL
  1. Stop the vehicle on a level place.

  1. C174596
    for Front Differential:

    1. Remove the engine under cover.

    2. Using a 10 mm hexagon wrench, remove the filler plug and gasket.

    3. Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.

    4. Using a 10 mm hexagon wrench, install a new gasket and the drain plug.

      Torque:
      39 N*m{ 400 kgf*cm , 29 ft.*lbf }

  1. for Rear Differential:

    1. Remove the filler plug and gasket.

    2. Remove the drain plug and gasket, and drain the oil.

    3. Install a new gasket and the drain plug.

      Torque:
      49 N*m{ 500 kgf*cm , 36 ft.*lbf }


2. REMOVE REAR AXLE SHAFT
  1. Remove the axle shaft (Click here).


3. DISCONNECT PROPELLER SHAFT ASSEMBLY

  1. C172482E01
    Place matchmarks on the rear propeller shaft and companion flange.

  1. Remove the 4 nuts, 4 washers and 4 bolts, and disconnect the propeller shaft from the differential side.

  1. Support the propeller shaft securely.


4. REMOVE REAR DIFFERENTIAL CARRIER SUB-ASSEMBLY

  1. C174037
    Remove the 10 nuts, 10 washers and differential carrier.

    NOTICE:
    Be careful not to damage the contact surfaces of the differential carrier and rear axle housing.

  1. Remove the gasket.

← COMPONENTS (from Sep 2011)DISASSEMBLY (from Sep 2011) →