Using SST and a hammer, tap in a new oil seal as shown in the illustration.
SST
09223-56010
Standard depth A:
2.7 to 3.7 mm (0.106 to 0.147 in.)
Text in Illustration
*1
Rear Engine Oil Seal Retainer
*2
Oil Seal
NOTICE:
Keep the lip free from foreign matter.
Do not tap on the seal at an angle.
Make sure that the lip of the oil seal is properly installed.
2.
INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)
Using a wrench, hold the crankshaft.
Install the rear crankshaft balancer weight.
Text in Illustration
Engine Side
HINT:
Align the pin hole of the rear crankshaft balancer weight with the pin of the crankshaft.
As the rear crankshaft balancer weight is not reversible, be sure to install it so that it is facing in the direction shown in the illustration.
Install the drive plate and ring gear and rear drive plate spacer with 8 new bolts.
Text in Illustration
*1
Drive Plate and Ring Gear
*2
Rear Drive Plate Spacer
Automatic Transmission Side
HINT:
As the drive plate and ring gear and rear drive plate spacer are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.
Install and uniformly tighten the 8 bolts in the sequence shown in the illustration.