HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jan 2012
- HINT:
- Use the following procedure to troubleshoot the parking assist monitor system (w/o Side Monitor System).
- *: Use the intelligent tester.
- Use the following procedure to troubleshoot the parking assist monitor system (w/o Side Monitor System).
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK NAVIGATION SYSTEM |
Refer to the navigation system (Click here).
Result Result
Proceed to
Navigation system is normal
A
Navigation system is abnormal
B
|
|||||
| |||||
| 4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
- for LHD: Click here
- for RHD: Click here
Result Result
Proceed to
CAN communication system DTCs are not output
A
CAN communication system DTCs are output (for LHD)
B
CAN communication system DTCs are output (for RHD)
C
- for LHD: Click here
|
|||||
|
|||||
| |||||
| 5.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs (Click here).
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
- NOTICE:
- The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the parking assist monitor system (w/o Side Monitor System) are output, refer to Diagnostic Trouble Code Chart for the applicable system.
Result
Proceed to
Audio and Visual System (w/ Navigation System)
Click here
Navigation System
Click here
Result Result
Proceed to
No DTCs are output.
A
DTCs are output.
B
|
|||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
Refer to the Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in Problem Symptoms Table
A
Fault is listed in Problem Symptoms Table
B
|
|||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING |
Diagnosis System (Click here).
Terminals of ECU (Click here).
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
| |||||