2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

TERMINALS OF ECU

System information · Vehicles built from Jan 2012


REAR TELEVISION CAMERA ASSEMBLY
E115535E11
  1. Disconnect the S5 rear television camera assembly connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    S5-4 (CB+) - S5-3 (CGND)
    B - BR
    Power source
    Engine switch on (IG), shift lever in R
    5.5 to 7.05 V
    S5-3 (CGND) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω

  3. Reconnect the S5 rear television camera assembly connector.

    HINT:
    A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the multi-media module receiver assembly with the connector connected.

  4. Measure the waveform according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    S5-2 (CV+) - S5-3 (CGND)
    R - BR
    Display signal
    Engine switch on (IG), shift lever in R
    Pulse generation( See waveform)
    S5-1 (CV-) - S5-3 (CGND)
    W - BR
    Rear television camera ground
    Always
    Below 1 V

  5. E171712E22
    Using an oscilloscope, check waveform.

    HINT:
    1. A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the navigation receiver assembly with the connector connected.
    2. The video waveform changes according to the image sent by the rear television camera assembly.


    1. Waveform

      Item
      Content
      Terminal No. (Symbol)
      S5-2 (CV+) - S5-3 (CGND)
      Tool Setting
      200 mV/DIV., 50 μsec./DIV.
      Condition
      Waveform A: Engine switch on (IG), shift lever in R and camera lens is not covered, displaying an image
      Waveform B: Engine switch on (IG), shift lever in R and camera lens is covered, blacking out the screen
      Text in Illustration 
      *a
      Waveform A (camera lens not covered, displaying an image)
      *b
      Waveform B (camera lens covered, blacking out the screen)
      *c
      Synchronization Signal
      *d
      Video Waveform


MULTI-MEDIA MODULE RECEIVER ASSEMBLY (Click here)

POWER BACK DOOR UNIT ASSEMBLY [w/ Power Back Door System] (Click here)

INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) [w/o Power Back Door System] (Click here)
← PROBLEM SYMPTOMS TABLE (from Jan 2012)DIAGNOSIS SYSTEM (from Jan 2012) →