2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

INITIALIZATION

Troubleshooting · Vehicles built Sep 2011 – Dec 2011


INITIALIZE PARKING ASSIST MONITOR SYSTEM
  1. If the following operations are performed, "SYSTEM INITIALIZING" is displayed on the display and navigation module display.

    Part Name
    Operation
    Initialization Item
    Battery cable
    Disconnect
    Store the steering angle neutral point in memory
    Steering angle sensor connector
    Disconnect
    Store the steering angle neutral point in memory

  2. When "SYSTEM INITIALIZING" is displayed, correct the steering angle neutral point using either of the following methods.

    1. METHOD 1:
      Fully turn the steering wheel to the right and left.

    2. METHOD 2:

      1. Drive the vehicle at more than 20 km/h (12 mph) for more than 5 minutes on a straight road with as little traffic congestion as possible.

        HINT:
        While driving at a constant vehicle speed, the ECU recognizes the point where the steering angle changes the least and memorizes it as the steering angle neutral point.

      2. Stop the vehicle and check whether the neutral point is stored or not. If it is not stored, drive the vehicle according to the previous step again (the neutral point is stored by driving the vehicle straight).

← HOW TO PROCEED WITH TROUBLESHOOTING (Sep 2011 – Dec 2011)CALIBRATION (Sep 2011 – Dec 2011) →