HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Sep 2011 – Dec 2011
- HINT:
- Use the following procedure to troubleshoot the parking assist monitor system.
- *: Use the intelligent tester.
- Use the following procedure to troubleshoot the parking assist monitor system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
Measure the battery voltage with the engine switch off.
- Standard Voltage:
- 11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.
| |||||
| 3.CHECK NAVIGATION SYSTEM |
Refer to the navigation system (for HDD) (Click here).
Refer to the navigation system (for DVD) (Click here).
Result Result
Proceed to
Navigation system is normal
A
Navigation system (for HDD) is abnormal
B
Navigation system (for DVD) is abnormal
C
|
|||||
|
|||||
| |||||
| 4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output (for LHD)
B
CAN DTC is output (for RHD)
C
|
|||||
|
|||||
| |||||
| 5.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTC (Click here).
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
Result Result
Proceed to
DTC is not output
A
DTC is output
B
|
|||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
Refer to the Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in Problem Symptoms Table
A
Fault is listed in Problem Symptoms Table
B
|
|||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Data List / Active Test (Click here)
Terminals of ECU (Click here)
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
| |||||