2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
Use the procedures to troubleshoot the rear view monitor system.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.INSPECT BATTERY VOLTAGE

        Standard Voltage:
        11 to 14 V

        If the voltage is below 11 V, replace or recharge the battery before proceeding.
      NEXT

      4.CHECK DTC OF NAVIGATION SYSTEM
      1. Refer to the DTC Check / Clear procedures of the navigation system.

        1. for HDD navigation system (Click here)
        2. for DVD navigation system (Click here)
        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output ( for HDD navigation system)
        B
        DTC is output ( for DVD navigation system)
        C


      B.

      C.
      A

      5.PROBLEM SYMPTOM CONFIRMATION
        Result 
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B

      B.
      A

      6.SYMPTOM SIMULATION
        NEXT

        7.CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM
        1. Refer to the navigation system.

          Result 
          Result
          Proceed to
          Symptom does not appear
          A
          Symptom appears (for HDD navigation system)
          B
          Symptom appears (for DVD navigation system)
          C


        B.

        C.
        A

        8.PROBLEM SYMPTOMS TABLE
        1. Refer to the Problem Symptoms Table (Click here).

          Result 
          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B


        B.
        A

        9.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW
        1. Terminals of ECU (Click here).

        NEXT

        10.ADJUST, REPAIR OR REPLACE
          NEXT

          11.CONFIRMATION TEST
            NEXT

            ← SYSTEM DESCRIPTION (from Jan 2012)HOW TO PROCEED WITH TROUBLESHOOTING (from Jan 2012) →