HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- HINT:
- Use the following procedures to troubleshoot the rear view monitor system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 4.CHECK DTC OF NAVIGATION SYSTEM |
Refer to the DTC Check / Clear procedures of the navigation system (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
B
|
|||||
| |||||
| 5.PROBLEM SYMPTOM CONFIRMATION |
| Result |
Proceed to |
| Symptom does not occur |
A |
| Symptom occurs |
B |
|
|||||
| |||||
| 6.SYMPTOM SIMULATION |
| |||||
| 7.CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM |
| Result |
Proceed to |
| Symptom does not appear |
A |
| Symptom appears (Audio and Visual System [w/ Navigation System]) |
B |
| Symptom appears (Navigation System) |
C |
| Symptom appears (Rear Seat Entertainment System) |
D |
|
|||||
|
|||||
|
|||||
| |||||
| 8.PROBLEM SYMPTOMS TABLE |
Refer to the Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 9.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW |
Terminals of ECU (Click here).
| |||||
| 10.ADJUST, REPAIR OR REPLACE |
| |||||
| 11.CONFIRMATION TEST |
| |||||