2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

TERMINALS OF ECU

System information · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


CHECK REAR TELEVISION CAMERA ASSEMBLY
E115535E11
  1. Disconnect the S5 rear television camera assembly connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    S5-3 (CGND) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω
    S5-4 (CB+) - S5-3 (CGND)
    B - BR
    Power source
    Engine switch on (IG), shift lever in R
    5.5 to 7.05 V

  3. Reconnect the S5 rear television camera assembly connector.

    HINT:
    The blind rear television camera assembly uses waterproof connector. Therefore, voltage cannot be checked with the connector connected to the vehicle.

  4. Measure the waveform according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    S5-2 (CV+) - S5-3 (CGND)
    R - BR
    Display signal
    Engine switch on (IG), shift lever in R
    Pulse generation (See waveform)
    S5-1 (CV-) - S5-3 (CGND)
    W - BR
    Rear television camera ground
    Always
    Below 1 V

  5. E171712E33
    Using an oscilloscope, check waveform.

    HINT:
    1. The video waveform changes according to the image sent by the rear television camera assembly.
    2. A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the multi-media module receiver assembly with the connector connected.

    Text in Illustration 
    *a
    Waveform A (camera lens not covered, displaying an image)
    *b
    Waveform B (camera lens covered, blacking out the screen)
    *c
    Synchronization Signal
    *d
    Video Waveform
    Waveform 
    Item
    Content
    Terminal No. (Symbol)
    S5-2 (CV+) - S5-3 (CGND)
    Tool Setting
    0.2 V/DIV., 50 μs/DIV.
    Condition
    Waveform A: Engine switch on (IG), shift lever in R and camera lens is not covered, displaying an image
    Waveform B: Engine switch on (IG), shift lever in R and camera lens is covered, blacking out the screen


CHECK MULTI-MEDIA MODULE RECEIVER ASSEMBLY (Click here)

CHECK MULTI-DISPLAY ASSEMBLY (Click here)
← TERMINALS OF ECU (Sep 2011 – Dec 2011)Reverse Signal Circuit (from Jan 2012) →