2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Reverse Signal Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

The multi-media module receiver assembly receives a reverse signal from the park/neutral position switch assembly.

WIRING DIAGRAM

E246942E01

INSPECTION PROCEDURE


1. CHECK MULTI-MEDIA MODULE RECEIVER ASSEMBLY (REVERSE SIGNAL)

  1. E245957E02
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F77-57 (REV) - Body ground
    Engine switch on (IG), shift lever in R
    11 to 14 V
    F77-57 (REV) - Body ground
    Engine switch on (IG), shift lever not in R
    Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Multi-media Module Receiver Assembly)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH ASSEMBLY)
  1. Disconnect the F77 multi-media module receiver assembly connector.

  1. Disconnect the C24 park/neutral position switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F77-57 (REV) - C24-1 (RL)
    Always
    Below 1 Ω
    F77-57 (REV) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)


← TERMINALS OF ECU (from Jan 2012)Display Signal Circuit between Multi-display and Television Camera Assembly (Sep 2011 – Dec 2011) →