B1675/82 Rear Floor Airbag Sensor Malfunction
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
The rear floor airbag sensor consists of the diagnostic circuit, the rear floor deceleration sensor, etc.If the center airbag sensor receives signals from the rear floor deceleration sensor, it determines whether the SRS should be activated.
DTC B1675/82 is stored when a malfunction is detected in the rear floor airbag sensor circuit.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B1675/82 |
When one of the following conditions is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (Click here).
| 1. CHECK REAR FLOOR AIRBAG SENSOR |
Turn the ignition switch off.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Temporarily replace the rear floor airbag sensor with a new one.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear the DTCs stored in the memory (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs (Click here).
- OK:
- DTC B1675 is not output.
- HINT:
- Codes other than DTC B1675 may be output at this time, but they are not related to this check.
|
|
||||
|
|
||||
| C | ||
| ||
