Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).
1.
INSTALL FRONT UPPER CENTER BUMPER RETAINER
Install the bumper retainer with the 3 bolts.
2.
INSTALL HEADLIGHT ASSEMBLY LH
for Standard: Install the headlight assembly LH (Click here).
for HID headlight: Install the headlight assembly LH (Click here).
3.
INSTALL HEADLIGHT ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
4.
INSTALL FRONT BUMPER SIDE SUPPORT LH
Attach the 3 clips to install the side support.
Install the 2 screws.
5.
INSTALL FRONT BUMPER SIDE SUPPORT RH
HINT:
Use the same procedures described for the LH side.
6.
INSTALL FRONT BUMPER EXTENSION LH
Install the bumper extension with the 3 bolts.
7.
INSTALL FRONT BUMPER EXTENSION RH
HINT:
Use the same procedures described for the LH side.
8.
INSTALL FRONT BUMPER COVER
w/o TOYOTA Parking Assist-sensor System, w/o Fog Light: Connect the winch control wire connector and attach the 10 claws to install the bumper cover.
w/ TOYOTA Parking Assist-sensor System or w/ Fog Light: Connect the No. 4 engine room wire connector and winch control wire connector, and attach the 10 claws to install the bumper cover.
Install the 3 clips, 4 screws and 4 bolts.
Using a T30 "TORX" socket, install the 6 screws.
9.
INSTALL RADIATOR GRILLE ASSEMBLY
Attach the 2 clips and 8 claws to install the radiator grille.
Install the 3 screws.
10.
INSTALL FRONT BUMPER WINCH COVER SUB-ASSEMBLY
11.
INSTALL UPPER RADIATOR SUPPORT SEAL
Install the radiator support seal with the 7 clips.
12.
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
Push in the clip indicated by the arrow in the illustration to install the fender splash shield.
Install the 3 bolts and screw.
13.
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
14.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for HID Headlight)
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).