2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REASSEMBLY

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. A bolt without a torque specification is shown in the standard bolt chart (Click here).
  2. When installing the front bumper protector, heat the front bumper surface using a heat light.

    Standard Heating Temperature:
    Item
    Temperature
    Front Bumper
    20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the front bumper excessively.


1. INSTALL WINCH CONTROL WIRE

  1. B180480
    Install the winch control wire with the 2 nuts.

    Torque:
    5 N*m{ 51 kgf*cm , 45 in.*lbf }


2. INSTALL FRONT LICENSE PLATE BRACKET (w/ Bracket)
  1. Install the front license plate bracket with the 2 nuts.


3. INSTALL FRONT NO. 2 BUMPER PROTECTOR
  1. Clean the front bumper cover surface.

    1. Using a heat light, heat the front bumper cover surface.

    2. Remove the double-sided tape from the front bumper cover.

    3. Wipe off any tape adhesive residue with cleaner.

  1. B302219
    Install new front No. 2 bumper protector.

    1. Remove the peeling paper from the face of new front No. 2 bumper protector.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    2. Install the 2 front No. 2 bumper protectors as shown in the illustration.


4. INSTALL LOWER RADIATOR GRILLE LH
  1. Attach the 6 claws to install the lower radiator grille LH.


5. INSTALL LOWER RADIATOR GRILLE RH

HINT:
Use the same procedure described for the LH side.


6. INSTALL FRONT BUMPER HOLE COVER LH (w/ Fog Light)
  1. Attach the 5 claws to the front bumper hole cover LH.

  1. Install the 2 screws and 2 retainers.


7. INSTALL FRONT BUMPER HOLE COVER RH (w/ Fog Light)

HINT:
Use the same procedure described for the LH side.


8. INSTALL FRONT BUMPER HOLE COVER LH (w/o Fog Light)
  1. Attach the 5 claws to the front bumper hole cover LH.

  1. Install the screw and 2 retainers.


9. INSTALL FRONT BUMPER HOLE COVER RH (w/o Fog Light)

HINT:
Use the same procedure described for the LH side.


10. INSTALL FOG LIGHT ASSEMBLY LH (w/ Fog Light)
  1. Connect the connector.

  1. Attach the 2 guides and install the fog light assembly LH.

  1. Install the 2 screws.


11. INSTALL FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Use the same procedure described for the LH side.


12. INSTALL FRONT BUMPER INNER BRACKET (w/ Fog Light)
  1. Attach the 3 claws and install the front bumper inner bracket.


13. INSTALL NO. 4 ENGINE ROOM WIRE (w/ Fog Light)
  1. Attach the 11 clamps to install the No. 4 engine room wire.

  1. Connect the 2 connectors.

← REASSEMBLY (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →