2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL FRONT UPPER CENTER BUMPER RETAINER
  1. Install the front upper center bumper retainer with the 3 bolts.


2. INSTALL HEADLIGHT ASSEMBLY LH
  1. for Halogen Headlight:
    (Click here)

  1. for HID Headlight:
    (Click here)


3. INSTALL HEADLIGHT ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.


4. INSTALL FRONT BUMPER SIDE SUPPORT LH
  1. Attach the 3 clips to install the front bumper side support LH.

  1. Install the 2 screws.


5. INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure described for the LH side.


6. INSTALL FRONT BUMPER EXTENSION LH
  1. Install the front bumper extension LH with the 3 bolts.


7. INSTALL FRONT BUMPER EXTENSION RH

HINT:
Use the same procedure described for the LH side.


8. INSTALL FRONT BUMPER COVER
  1. w/ Fog Light:
    Connect the No. 4 engine room wire connector.

  1. Connect the winch control wire connector and attach the 10 claws to install the front bumper cover.

  1. Install the 3 clips, 4 screws and 4 bolts.

  1. Using a T30 "TORX" socket, install the 6 screws.


9. INSTALL RADIATOR GRILLE ASSEMBLY

  1. B302174E01
    Put protective tape around the radiator grille assembly.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 3 screws.

  1. Detach the 2 clips and 8 claws, and remove the radiator grille assembly.

  1. w/ Wide View Front Monitor System:

    1. Disconnect the connector.


10. INSTALL FRONT BUMPER WINCH COVER SUB-ASSEMBLY
  1. Attach the 3 guides.

  1. Attach the 2 claws and front bumper winch cover sub-assembly.


11. INSTALL UPPER RADIATOR SUPPORT SEAL

  1. Install the radiator support seal with the 7 clips.

    B180890E02


12. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
  1. Push in the clip to install the front fender splash shield sub-assembly LH.

  1. Install the 3 bolts and screw.


13. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
  1. Push in the clip to install the front fender splash shield sub-assembly RH.

  1. Install the 3 bolts and 2 screws.


14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for HID Headlight)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


15. ADJUST HEADLIGHT AIMING
  1. for Halogen Headlight:

    1. (Click here)

  1. for HID Headlight:

    1. (Click here)


16. ADJUST FOG LIGHT AIMING (w/ Fog Light)
(Click here)
← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (from Sep 2011) →