2011-2013 Land Cruiser · Service Manual Vehicle Exterior

DISASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE NO. 2 FRAME WIRE

  1. w/ TOYOTA Parking Assist-sensor System, w/ Rear Fog Light:
    Remove the No. 2 frame wire.

    1. Disconnect the 6 connectors.

    2. Detach the 16 clamps and remove the frame wire.

      B184219

  1. w/ TOYOTA Parking Assist-sensor System, w/o Rear Fog Light:
    Remove the No. 2 frame wire.

    1. Disconnect the 4 connectors.

    2. Detach the 14 clamps and remove the frame wire.

      B183028

  1. w/o TOYOTA Parking Assist-sensor System, w/ Rear Fog Light:
    Remove the No. 2 frame wire.

    1. Disconnect the 2 connectors.

    2. Detach the 13 clamps and remove the frame wire.

      B185557


2. REMOVE NO. 2 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

E156760

HINT:
Use the same procedure to remove the No. 2 ultrasonic sensor on the other side.

  1. While pushing down on the lever with a finger to release the one claw, detach the claw on the other side to remove the ultrasonic sensor.

    HINT:
    The type of claw on the top and bottom of the sensor are different. Observe the claws carefully before removing the sensor.


3. REMOVE NO. 3 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

E157382

HINT:
Use the same procedure to remove the No. 3 ultrasonic sensor on the other side.

  1. Detach the claw and remove the ultrasonic sensor as shown in the illustration.


4. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

E156761

HINT:
Use the same procedure to remove the No. 2 ultrasonic sensor retainer on the other side.

  1. Detach the 2 claws and remove the ultrasonic sensor retainer from the rear bumper cover.


5. REMOVE NO. 3 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

E128340E01

HINT:
Use the same procedure to remove the No. 3 ultrasonic sensor retainer on the other side.

  1. Detach the claw and remove the ultrasonic sensor retainer from the rear bumper cover.


6. REMOVE REAR BUMPER ENERGY ABSORBER

B181017
  1. Detach the 8 claws and remove the energy absorber.


7. REMOVE REAR FOG LIGHT ASSEMBLY LH

B181016
  1. Remove the 2 nuts.

  1. Detach the claw and remove the fog light.


8. REMOVE REAR FOG LIGHT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


9. REMOVE REAR LOWER BUMPER COVER
  1. Remove the clip and rear lower bumper cover.


10. REMOVE REAR NO. 2 STEP COVER

B181018
  1. Remove the 2 screws and 2 clips.

  1. Detach the 4 claws and remove the step cover.

← REMOVAL (from Jan 2012)DISASSEMBLY (from Jan 2012) →