REMOVAL
Removal / installation · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2.
REMOVE REAR STEP COVER (w/ Sliding Roof)
|
 |
- HINT:
- Use the same procedure to remove the step cover on the other side.
Detach the 2 claws and remove the step cover.
| 3.
REMOVE REAR STEP COVER (w/o Sliding Roof)
|
 |
- HINT:
- Use the same procedure to remove the step cover on the other side.
Detach the 2 claws and remove the step cover.
| 4.
REMOVE REAR DOOR SCUFF PLATE LH (w/ Sliding Roof)
|
 |
Remove the screw.
Detach the 3 claws and 4 clips, and remove the scuff plate.
| 5.
REMOVE REAR DOOR SCUFF PLATE LH (w/o Sliding Roof)
|
 |
Remove the screw.
Detach the 3 claws and 4 clips, and remove the scuff plate.
| 6.
REMOVE REAR DOOR SCUFF PLATE RH (w/ Sliding Roof)
|
 |
- HINT:
- Use the same procedures described for the LH side.
| 7.
REMOVE REAR DOOR SCUFF PLATE RH (w/o Sliding Roof)
|
 |
- HINT:
- Use the same procedures described for the LH side.
| 8.
REMOVE REAR FLOOR AIRBAG SENSOR |
 |
Fold back the floor carpet.
- Detach the clip and claw, and remove the cover.
- Remove the bolt and sensor.
Disconnect the connector.