2011-2013 Land Cruiser · Service Manual Suspension

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

Kinetic Dynamic Suspension System 
Symptom
Suspected Area
See page
The height of the left and right side of the vehicle is different
After confirming the difference between the left and right sides, perform vehicle tilt calibration
Click here
The height of the left and right side of the vehicle is different even after performing vehicle tilt calibration
Perform air bleeding
Click here
The height of the left and right side of the vehicle is different even after bleeding air
Front stabilizer control cylinder
Click here
Rear stabilizer control cylinder
Click here
Stabilizer control with accumulator housing assembly
Click here
Excessive roll (Decrease in roll stiffness)
Bush parts are missing or damaged
-
Oil leakage
Click here
Perform air bleeding
Click here
Excessive roll even after bleeding air
Stabilizer control with accumulator housing assembly
Click here
Excessive roll even after replacing stabilizer control with accumulator housing assembly
Front stabilizer control cylinder
Click here
Rear stabilizer control cylinder
Click here
← PROBLEM SYMPTOMS TABLE (Sep 2011 – Dec 2011)ON-VEHICLE INSPECTION (from Sep 2011) →