2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the RHD and LHD.
  2. The procedures listed below are the LHD side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

B183763
  1. Detach the 8 claws and remove the opening cover.


3. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

B180307E02
  1. Place protective tape as shown in the illustration.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 6 claws.

  1. Disconnect the connector and remove the No. 3 instrument panel register.


4. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

B181944E02
  1. Place protective tape as shown in the illustration.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 6 claws.

  1. Disconnect the connector and remove the No. 4 instrument panel register.


5. REMOVE RADIO RECEIVER ASSEMBLY (w/ Radio Receiver)

  1. B181490
    Remove the 2 screws and 2 bolts.

  1. Disconnect the connectors and remove the radio receiver.


6. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (w/o Radio Receiver)

B183763
  1. Detach the 8 claws and remove the opening cover.


7. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

  1. E155869
    Detach the 2 claws and remove the hazard warning switch.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (from Sep 2011) →