2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. INSTALL FRONT SEAT ASSEMBLY LH
  1. Place the front seat assembly LH in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. w/ Wire Harness:
    Connect the connectors under the front seat assembly LH.

  1. Temporarily install the front seat assembly LH with the 4 bolts.

  1. Operate the seat track adjusting handle to move the front seat assembly LH to the rearmost position.

  1. B188505E01
    Tighten the bolts in the order indicated in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Operate the seat track adjusting handle to move the front seat assembly LH to the foremost position.

  1. B188506E01
    Tighten the bolts in the order indicated in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. w/ Front Seat Side Airbag:
    Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here)

  1. for Power Tilt and Power Telescopic Steering Column:
    Restore the Autoaway/Return function setting to the previous condition by changing the customize parameter (Click here)


2. INSTALL REAR INNER SEAT TRACK BRACKET COVER LH

B180785
  1. Attach the 3 claws to install the rear inner seat track bracket cover LH.


3. INSTALL REAR OUTER FRONT SEAT TRACK COVER LH

B180784
  1. Attach the 3 claws to install the rear outer front seat track cover LH.


4. INSTALL FRONT INNER SEAT TRACK BRACKET COVER LH

B180783
  1. Attach the 2 claws to install the front inner seat track bracket cover LH.


5. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER LH

B180782
  1. Attach the 2 claws to install the front outer seat track bracket cover LH.


6. INSTALL FRONT SEAT HEADREST ASSEMBLY
  1. Install the front seat headrest assembly.


7. CHECK SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(Click here)

8. INSPECT FRONT SEAT ASSEMBLY (w/ Lumbar Support)
  1. Check the lumbar support operation.

    1. Operate the lumbar switch and check that the lumbar support moves in both directions.

← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (Sep 2011 – Dec 2011) →