2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE REAR NO. 3 SEAT CUSHION HINGE COVER

B258451
  1. Using a screwdriver, detach the 6 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE REAR NO. 5 SEAT CUSHION HINGE COVER

B261018
  1. Using a screwdriver, detach the 7 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE REAR NO. 2 SEAT CUSHION HINGE COVER

  1. B182644
    Operate the reclining adjuster release handle to move the seat into the position shown in the illustration.

  1. B181218
    Using a screwdriver, detach the 2 claws and 2 clips, and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


5. REMOVE REAR NO. 4 SEAT CUSHION HINGE COVER

  1. B181217
    Using a screwdriver, detach the 2 claws and 2 clips, and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


6. REMOVE REAR NO. 1 SEAT ASSEMBLY LH

  1. B184034
    w/ Rear Seat Side Airbag:
    Disconnect the connector.

  1. w/ Seat Heater System:
    Disconnect the connector.

  1. B181219
    Remove the 4 bolts and seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.


7. REMOVE REAR NO. 1 SEAT ASSEMBLY RH
  1. Remove the rear No. 1 seat assembly RH (Click here).


8. REMOVE REAR NO. 1 SEAT PROTECTOR

  1. B184032E01
    Detach the 10 claws and remove the 2 seat protectors.


9. REMOVE REAR NO. 2 SEAT PROTECTOR

  1. B184031E01
    Detach the 10 claws and remove the 2 seat protectors.


10. REMOVE REAR STEP COVER

B181673

HINT:
Use the same procedure to remove the step cover on the other side.

  1. Detach the 2 claws and remove the step cover.


11. REMOVE REAR DOOR SCUFF PLATE LH

B181674
  1. Remove the screw.

  1. Detach the 3 claws and 4 clips, and remove the scuff plate.


12. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.


13. REMOVE REAR NO. 2 SEAT ASSEMBLY
  1. for Face to Face Seat Type:
    Remove the rear No. 2 seat assembly (Click here).

  1. except Face to Face Seat Type:
    Remove the rear No. 2 seat assembly (Click here).


14. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

B181672
  1. Detach the 6 clips and remove the support plate.


15. REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

B190187E01

HINT:
Use the same procedure to remove the rear seat cover cap on the other side.

  1. Using a screwdriver, detach the 3 claws and remove the rear seat cover cap.

    HINT:
    Tape the screwdriver tip before use.


16. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
  1. w/ Sliding Roof:
    Remove the front quarter trim panel assembly LH (Click here).

  1. w/o Sliding Roof:
    Remove the front quarter trim panel assembly LH (Click here).


17. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
  1. w/ Sliding Roof:
    Remove the front quarter trim panel assembly RH (Click here).

  1. w/o Sliding Roof:
    Remove the front quarter trim panel assembly RH (Click here).


18. REMOVE AIR DUCT PLUG (w/ Rear Air Conditioning System)

  1. B183333
    Detach the 2 claws and remove the plug.

    HINT:
    Use the same procedures for both sides.


19. REMOVE REAR AIR DUCT GUIDE (w/ Rear Air Conditioning System)

  1. B183334
    Remove the screw.

  1. Detach the claw and remove the guide.

    HINT:
    Use the same procedures for both sides.


20. REMOVE FRONT FLOOR CARPET ASSEMBLY

E157065
  1. Fold back the floor carpet.

    HINT:
    Fold back the carpet until it is possible to remove the rear No. 6 air duct.


21. REMOVE REAR NO. 6 AIR DUCT (w/ Rear Air Conditioning System)
  1. Disconnect the 2 connectors.

  1. Remove the 5 screws and duct.

    E155886


22. REMOVE REAR SEAT CUSHION LOCK STRIKER SUB-ASSEMBLY

B184033E01
  1. Remove the 10 bolts and 4 lock strikers.

← COMPONENTS (from Sep 2011)REMOVAL (from Jan 2012) →