2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE REAR NO. 3 SEAT CUSHION HINGE COVER

B258451
  1. Using a screwdriver, detach the 6 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE REAR NO. 5 SEAT CUSHION HINGE COVER

B261018
  1. Using a screwdriver, detach the 7 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


5. REMOVE REAR NO. 2 SEAT CUSHION HINGE COVER

  1. B182644
    Operate the reclining adjuster release handle to move the seat into the position shown in the illustration.

  1. B181218
    Using a screwdriver, detach the 2 claws and 2 clips, and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


6. REMOVE REAR NO. 4 SEAT CUSHION HINGE COVER

  1. B181217
    Using a screwdriver, detach the 2 claws and 2 clips, and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


7. REMOVE REAR NO. 1 SEAT ASSEMBLY LH

  1. B184034
    w/ Rear Seat Side Airbag:
    Disconnect the connector.

  1. w/ Seat Heater System:
    Disconnect the connector.

  1. B181219
    Remove the 4 bolts and seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.


8. REMOVE REAR NO. 1 SEAT ASSEMBLY RH
  1. Remove the rear No. 1 seat assembly RH (Click here).


9. REMOVE REAR NO. 1 SEAT PROTECTOR

  1. B184032E01
    Detach the 10 claws and remove the 2 seat protectors.


10. REMOVE REAR NO. 2 SEAT PROTECTOR

  1. B184031E01
    Detach the 10 claws and remove the 2 seat protectors.


11. REMOVE REAR STEP COVER

B181673

HINT:
Use the same procedure to remove the step cover on the other side.

  1. Detach the 2 claws and remove the step cover.


12. REMOVE REAR DOOR SCUFF PLATE LH

B181674
  1. Remove the screw.

  1. Detach the 3 claws and 4 clips, and remove the scuff plate.


13. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.


14. REMOVE REAR NO. 2 SEAT ASSEMBLY
  1. for Face to Face Seat Type:
    Remove the rear No. 2 seat assembly (Click here).

  1. except Face to Face Seat Type:
    Remove the rear No. 2 seat assembly (Click here).


15. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

B181672
  1. Detach the 6 clips and remove the support plate.


16. REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

B190187E01

HINT:
Use the same procedure to remove the rear seat cover cap on the other side.

  1. Using a screwdriver, detach the 3 claws and remove the rear seat cover cap.

    HINT:
    Tape the screwdriver tip before use.


17. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
  1. w/ Sliding Roof:
    Remove the front quarter trim panel assembly LH (Click here).

  1. w/o Sliding Roof:
    Remove the front quarter trim panel assembly LH (Click here).


18. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
  1. w/ Sliding Roof:
    Remove the front quarter trim panel assembly RH (Click here).

  1. w/o Sliding Roof:
    Remove the front quarter trim panel assembly RH (Click here).


19. REMOVE AIR DUCT PLUG (w/ Rear Air Conditioning System)

  1. B183333
    Detach the 2 claws and remove the plug.

    HINT:
    Use the same procedures for both sides.


20. REMOVE REAR AIR DUCT GUIDE (w/ Rear Air Conditioning System)

  1. B183334
    Remove the screw.

  1. Detach the claw and remove the guide.

    HINT:
    Use the same procedures for both sides.


21. REMOVE FRONT FLOOR CARPET ASSEMBLY

E157065
  1. Fold back the floor carpet.

    HINT:
    Fold back the carpet until it is possible to remove the rear No. 6 air duct.


22. REMOVE REAR NO. 6 AIR DUCT (w/ Rear Air Conditioning System)
  1. Disconnect the 2 connectors.

  1. Remove the 5 screws and duct.

    E155886


23. REMOVE REAR SEAT CUSHION LOCK STRIKER SUB-ASSEMBLY

B184033E01
  1. Remove the 10 bolts and 4 lock strikers.

← REMOVAL (Sep 2011 – Dec 2011)DISASSEMBLY (from Sep 2011) →