2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat assembly (Click here).


2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

B180697E02
  1. Apply protective tape as shown in the illustration.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver, detach the 2 claws and remove the slide and vertical power seat switch knob.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE RECLINING POWER SEAT SWITCH KNOB

B180698E02
  1. Using a screwdriver, detach the 2 claws and remove the reclining power seat switch knob.

    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE FRONT SEAT CUSHION SHIELD LH

B180699
  1. Remove the 2 screws.

  1. Disconnect the 2 rubber bands.

  1. B180700
    Remove the 3 screws.

  1. Detach the 2 claws and remove the front seat cushion shield LH together with the front inner No. 1 seat cushion shield LH.

  1. for Driver Side:
    Disconnect the connector.


5. REMOVE FRONT POWER SEAT SWITCH LH

B180704
  1. Disconnect the switch connector.

  1. Remove the 3 screws and switch.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (from Sep 2011) →