REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
| 1.
REMOVE FRONT SEAT ASSEMBLY LH |
 |
Remove the front seat assembly (Click here).
| 2.
REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
|
 |
Apply protective tape around the cushion shield.
Using a screwdriver, detach the 2 claws and remove the knob.
- HINT:
- Tape the screwdriver tip before use.
| 3.
REMOVE RECLINING POWER SEAT SWITCH KNOB
|
 |
Using a screwdriver, detach the 2 claws and remove the knob.
- HINT:
- Tape the screwdriver tip before use.
| 4.
REMOVE FRONT SEAT CUSHION SHIELD LH
|
 |
Disconnect the 2 rubber bands from the 2 hooks.
Remove the 2 screws.
- Remove the 3 screws.
Detach the 2 claws and remove the cushion shield.
for Driver Side:
Disconnect the lumbar switch connector.
| 5.
REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
|
 |
Disconnect the connectors and detach the clamps.
- Remove the nut and front seat inner belt assembly.
| 6.
REMOVE FRONT INNER SEAT CUSHION SHIELD LH
|
 |
Remove the screw.
Detach the 2 claws and clip, and then remove the cushion shield.
| 7.
REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH
|
 |
Remove the 2 screws.
Move the seatback board in the direction of the arrow to detach the 2 hooks and remove the seatback board.
| 8.
REMOVE FRONT SEAT HEADREST SUPPORT
|
 |
Using a screwdriver, detach the 4 claws and remove the 2 headrest supports.
| 9.
REMOVE SEATBACK COVER WITH PAD |
 |
- Disconnect the seat heater connector and detach the 2 wire harness clamps.
- Remove the 3 hog rings and detach the 9 hooks.
- Remove the nut and seatback cover bracket from the seat frame.
Remove the seatback cover with pad.
| 10.
REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH |
 |
- Remove the 4 springs.
Remove the cable clamp and disconnect the active headrest cable from the seatback spring.
Detach the 4 hooks and remove the seatback spring.
- Disconnect the lumbar support adjuster connector.
Remove the 2 screws and lumbar support adjuster.