2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat assembly (Click here).


2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

B180697E01
  1. Apply protective tape around the cushion shield.

  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE RECLINING POWER SEAT SWITCH KNOB

B180698E01
  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE FRONT SEAT CUSHION SHIELD LH

B180699
  1. Disconnect the 2 rubber bands from the 2 hooks.

  1. Remove the 2 screws.

  1. B180700
    Remove the 3 screws.

  1. Detach the 2 claws and remove the cushion shield.

  1. for Driver Side:
    Disconnect the lumbar switch connector.


5. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
  1. Disconnect the connectors and detach the clamps.

  1. B185874
    Remove the nut and front seat inner belt assembly.


6. REMOVE FRONT INNER SEAT CUSHION SHIELD LH

B180703
  1. Remove the screw.

  1. Detach the 2 claws and clip, and then remove the cushion shield.


7. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH

B180711
  1. Remove the 2 screws.

  1. Move the seatback board in the direction of the arrow to detach the 2 hooks and remove the seatback board.


8. REMOVE FRONT SEAT HEADREST SUPPORT

B180712
  1. Using a screwdriver, detach the 4 claws and remove the 2 headrest supports.


9. REMOVE SEATBACK COVER WITH PAD

  1. B180706
    Disconnect the seat heater connector and detach the 2 wire harness clamps.

  1. B180713E01
    Remove the hog rings and detach the 9 hooks.

  1. B180716
    Remove the nut and seatback cover bracket from the seat frame.

  1. Remove the seatback cover with pad.


10. REMOVE FRONT SEPARATE TYPE SEATBACK COVER

  1. B180717
    Disconnect the seatback cover bracket from the seatback pad.

  1. B180718E01
    Remove the hog rings.

  1. Detach the fastening tape and remove the seatback cover.


11. REMOVE FRONT SEATBACK HEATER ASSEMBLY LH

  1. B180719
    Cut off the tack pins which fasten the seatback heater to the seatback cover, and then remove the seatback heater from the seatback cover.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →