Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
1.
INSTALL DOOR CONTROL RECEIVER
Install the receiver with the bolt.
Torque:
15 N*m{
153 kgf*cm
, 11 ft.*lbf
}
Connect the connector.
2.
INSTALL REAR UPPER PILLAR GARNISH RH
HINT:
Use the same procedures described for the LH side.
3.
INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH
HINT:
When installing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.
w/ Rear No. 2 Seat, except Face to Face Seat Type:
w/o Rear Air Conditioning System: Connect the rear seat lock control lever cable.
w/ Rear Air Conditioning System: Connect the thermistor connector and rear seat lock control lever cable.
Attach the 16 clips and 2 claws to install the quarter trim panel.
Install the clip and bolt.
Torque:
12 N*m{
122 kgf*cm
, 9 ft.*lbf
}
w/o Rear No. 2 Seat or w/ Rear No. 2 Seat, for Face to Face Seat Type:
Attach the 16 clips and 2 claws to install the quarter trim panel.
Install the clip.
w/ Rear No. 2 Seat, except Face to Face Seat Type:
Install the rear No. 2 seat belt anchor with the bolt.
Torque:
42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
Attach the 3 claws to install the cover.
Install the rear No. 1 seat belt anchor with the bolt.
Torque:
42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
Attach the 3 claws to install the cover.
4.
INSTALL REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)
HINT:
Use the same procedure to install the rear seat cover cap on the other side.
Attach the 3 claws to install the rear seat cover cap.