2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER

HINT:
Use the same procedure to install the No. 2 ultrasonic sensor retainer on the other side.

  1. E244160E01
    Temporarily install the No. 2 ultrasonic sensor retainer to the front bumper.
    Text in Illustration 
    *a
    Protrusion
    *b
    Keyhole

    NOTICE:
    1. Do not damage the bumper with the protrusion when installing the retainer.
    2. Securely install the No. 2 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the front bumper.

  1. E244159
    Attach the 2 claws to install the No. 2 ultra sonic sensor retainer.


2. INSTALL NO. 1 ULTRASONIC SENSOR

HINT:
Use the same procedure to install the No. 1 ultrasonic sensor on the other side.

  1. Attach the 2 claws to install the ultrasonic sensor.

    NOTICE:
    Push the No. 2 ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the No. 1 ultrasonic sensor.


3. INSTALL ULTRASONIC SENSOR CLIP
  1. Attach the 4 claws to install the ultrasonic sensor clip.

    NOTICE:
    Hold the No. 1 ultrasonic sensor in place so that the No. 2 ultrasonic sensor retainer does not come out when installing the ultrasonic sensor clip.


4. INSTALL NO. 4 ENGINE ROOM WIRE
  1. w/o TOYOTA Parking Assist-sensor System, w/ Fog Light:
    Install the No. 4 engine room wire.

    1. Attach the 11 clamps to install the No. 4 engine room wire.

    2. Connect the 2 connectors.

  1. w/ TOYOTA Parking Assist-sensor System, w/ Fog Light:
    Install the No. 4 engine room wire.

    1. Attach the 12 clamps to install the No. 4 engine room wire.

    2. Connect the 4 connectors.

  1. w/ TOYOTA Parking Assist-sensor System, w/o Fog Light:
    Install the No. 4 engine room wire.

    1. Attach the 12 clamps to install the No. 4 engine room wire.

    2. Connect the 2 connectors.


5. INSTALL FRONT BUMPER COVER
(Click here)
← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (Sep 2011 – Dec 2011) →