INSTALLATION
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER |
![]() ![]() |
- HINT:
- Use the same procedure to install the No. 1 ultrasonic sensor retainer on the other side.
Align the keyhole and protrusion as shown in the illustration.
Install the ultrasonic sensor retainer to the front bumper cover.
- NOTICE:
- Do not damage the bumper with the protrusion when installing the retainer.
| 2. INSTALL NO. 1 ULTRASONIC SENSOR |
![]() ![]() |
- HINT:
- Use the same procedure to install the No. 1 ultrasonic sensor on the other side.
Attach the 2 claws to install the ultrasonic sensor.
Connect the connector.
| 3. INSTALL NO. 4 ENGINE ROOM WIRE |
for Standard:
Install the No. 4 engine room wire (Click here).
w/ Winch:
Install the No. 4 engine room wire (Click here).
| 4. INSTALL FRONT BUMPER COVER |
for Standard:
Install the front bumper cover (Click here).
w/ Winch:
Install the front bumper cover (Click here).



