DATA LIST / ACTIVE TEST
System information · Vehicles built from Sep 2011
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Data List.
According to the display on the intelligent tester, read the Data List.
Mirror Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Driver Side SET Mem SW
Driver side seat memory SET switch / ON or OFF
ON: Driver side seat memory SET switch on
OFF: Driver side seat memory SET switch off
-
Driver Side Memory SW 1
Driver side seat memory switch 1 / ON or OFF
ON: Driver side seat memory switch 1 on
OFF: Driver side seat memory switch 1 off
-
Driver Side Memory SW 2
Driver side seat memory switch 2 / ON or OFF
ON: Driver side seat memory switch 2 on
OFF: Driver side seat memory switch 2 off
-
Driver Side Memory SW 3
Driver side seat memory switch 3 / ON or OFF
ON: Driver side seat memory switch 3 on
OFF: Driver side seat memory switch 3 off
-
Driver Seat Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Reclining Rear
Reclining switch signal (Rearward) / ON or OFF
ON: Reclining switch (Rearward) on
OFF: Reclining switch (Rearward) off
-
Reclining Front
Reclining switch signal (Forward) / ON or OFF
ON: Reclining switch (Forward) on
OFF: Reclining switch (Forward) off
-
Front Vertical Down
Front vertical switch signal (Downward) / ON or OFF
ON: Front vertical switch (Downward) on
OFF: Front vertical switch (Downward) off
-
Front Vertical Up
Front vertical switch signal (Upward) / ON or OFF
ON: Front vertical switch (Upward) on
OFF: Front vertical switch (Upward) off
-
Lifter Switch Down
Lifter switch signal (Downward) / ON or OFF
ON: Lifter switch (Downward) on
OFF: Lifter switch (Downward) off
-
Lifter Switch Up
Lifter switch signal (Upward) / ON or OFF
ON: Lifter switch (Upward) on
OFF: Lifter switch (Upward) off
-
Slide Rear
Sliding switch signal (Rearward) / ON or OFF
ON: Sliding switch (Rearward) on
OFF: Sliding switch (Rearward) off
-
Slide Front
Sliding switch signal (Forward) / ON or OFF
ON: Sliding switch (Forward) on
OFF: Sliding switch (Forward) off
-
SET Switch
Seat memory SET switch signal / ON or OFF
ON: Seat memory SET switch on
OFF: Seat memory SET switch off
-
M1 Switch
Seat memory switch 1 signal / ON or OFF
ON: Seat memory switch 1 on
OFF: Seat memory switch 1 off
-
M2 Switch
Seat memory switch 2 signal / ON or OFF
ON: Seat memory switch 2 on
OFF: Seat memory switch 2 off
-
M3 Switch
Seat memory switch 3 signal / ON or OFF
ON: Seat memory switch 3 on
OFF: Seat memory switch 3 off
-
Seat Memory No1
Seat position memorized with seat memory switch 1 / Mem or Not Mem
Mem: Memorized
Not Mem: Not memorized
-
Seat Memory No2
Seat position memorized with seat memory switch 2 / Mem or Not Mem
Mem: Memorized
Not Mem: Not memorized
-
Seat Memory No3
Seat position memorized with seat memory switch 3 / Mem or Not Mem
Mem: Memorized
Not Mem: Not memorized
-
Ignition Switch
Communication state of engine switch signal / ON or OFF
ON: Engine switch on (IG) signal is received
OFF: Engine switch off signal is not received
-
Key Switch
Engine switch status (IG) / ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
Key Code Conf
Recognition code is registered / ON or OFF
ON: One more recognition codes registered
OFF: No recognition code registered
-
D-Door Courtesy
Door courtesy switch signal / ON or OFF
ON: Driver side door open
OFF: Driver side door closed
-
P Switch
Shift lever position P signal / ON or OFF
ON: Shift lever in P
OFF: Shift lever not in P
-
Parking Brake SW
Parking brake switch status / ON or OFF
ON: Parking brake operated
OFF: Parking brake released
-
Vehicle Speed
Vehicle speed data / Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
Actual vehicle speed
-
Power Voltage
Power supply for driver seat ECU / MIN: 0 V, MAX: 19.89 V
Within range from 11 V to 14 V
-
Slide Position
Seat sliding position / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
Reclining Position
Seatback position / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
Front Vertical Position
Seat front vertical position / MIN: 4096 MAX: 61440
Within range from 4096 to 61440
-
Lifter Position
Seat lifter position / MIN: 4096 MAX: 61440
Within range from 4096 to 61440
-
Slide Pos Mem No1
Seat sliding position memorized with seat memory switch 1 / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
Reclining Pos Mem No1
Seatback position memorized with seat memory switch 1 / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
Frnt Vrtcl Pos Mem No1
Front vertical position memorized with seat memory switch 1 / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
Lifter Pos Mem No1
Lifter position memorized with seat memory switch 1 / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
Slide Pos Mem No2
Seat sliding position memorized with seat memory switch 2 / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
Reclining Pos Mem No2
Seatback position memorized with seat memory switch 2 / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
Frnt Vrtcl Pos Mem No2
Front vertical position memorized with seat memory switch 2 / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
Lifter Pos Mem No2
Lifter position memorized with seat memory switch 2 / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
Slide Pos Mem No3
Seat sliding position memorized with seat memory switch 3 / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
Reclining Pos Mem No3
Seatback position memorized with seat memory switch 3 / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
Frnt Vrtcl Pos Mem No3
Front vertical position memorized with seat memory switch 3 / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
Lifter Pos Mem No3
Lifter position memorized with seat memory switch 3 / MIN: 4096, MAX: 61440
Within range from 4096 to 61440
-
| ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Active Test.
According to the display on the intelligent tester, perform the Active Test.
Driver Seat Tester Display
Test Part
Control Range
Diagnostic Note
Seat Reclining
Seat reclining operation
Front / OFF / Rear
-
Front Vertical Operation
Seat front vertical operation
Up / OFF / Down
-
Lifter Operation
Seat lifter operation
Up / OFF / Down
-
Seat Slide Operation
Seat sliding operation
Front / OFF / Rear
-
Buzzer
Buzzer operation
ON / OFF
-