Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
1.
CONNECT NO. 2 STEERING INTERMEDIATE SHAFT
Align the part of the dust cover labeled A with the No. 2 steering intermediate shaft, and install the No. 2 steering intermediate shaft assembly to the steering link assembly.
Attach the 7 claws to install the No. 2 instrument panel finish panel cushion.
21.
INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Using pliers, grip the claws of the clamp and install the combination switch assembly with spiral cable sub-assembly to the steering column assembly with the clamp.
Connect the connectors to the combination switch with spiral cable.
22.
INSTALL UPPER STEERING COLUMN COVER
Attach the claw to install the upper steering column cover.
Attach the 4 clips to install the upper steering column cover onto the instrument cluster finish panel.
23.
INSTALL LOWER STEERING COLUMN COVER
Attach the 2 claws to install the lower steering column cover.
NOTICE:
Do not damage the tilt and telescopic switch.
Install the 3 screws.
Torque:
2.0 N*m{
20 kgf*cm
, 18 in.*lbf
}
24.
INSTALL STEERING WHEEL ASSEMBLY
Align the matchmarks on the steering wheel assembly and steering main shaft assembly.
Install the steering wheel assembly set nut.
Torque:
50 N*m{
510 kgf*cm
, 37 ft.*lbf
}
25.
INSTALL STEERING PAD
Support the steering pad with one hand.
Connect the 2 connectors to the steering pad.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
Connect the horn connector.
Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel.
Using a T30 "TORX" socket wrench, tighten the 2 screws.
Torque:
8.8 N*m{
90 kgf*cm
, 78 in.*lbf
}
26.
INSTALL LOWER NO. 2 STEERING WHEEL COVER
Attach the 2 claws to install the cover.
27.
INSTALL LOWER NO. 3 STEERING WHEEL COVER
Attach the 2 claws to install the cover.
28.
CHECK FRONT WHEELS FACING STRAIGHT AHEAD
29.
INSTALL FRONT WHEELS
30.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).