REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Discharge the fuel system pressure (Click here).
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 3. REMOVE SPARE TIRE |
| 4. REMOVE TAILPIPE ASSEMBLY |
Remove the bolt, clamp and gasket.
Remove the tailpipe from the 2 exhaust pipe supports.
| 5. REMOVE SPARE WHEEL CARRIER CROSSMEMBER AND SPARE WHEEL CARRIER BRACKET |
Remove the bolt labeled A, and then loosen the 4 bolts labeled B.


Slightly raise the spare wheel carrier crossmember, and then remove the 6 bolts labeled C, spare wheel carrier crossmember and 2 brackets.
| 6. REMOVE NO. 1 SPARE WHEEL STOPPER |
Remove the 2 bolts and spare wheel stopper.

| 7. REMOVE FUEL TANK CAP ASSEMBLY |
| 8. DISCONNECT FUEL TANK EVAPORATION VENT TUBE SUB-ASSEMBLY |
Disconnect the 2 fuel tank evaporation vent tubes.

| 9. DISCONNECT FUEL HOSE |
![]() ![]() |
| 10. DISCONNECT FUEL TANK BREATHER HOSE |
Disconnect the breather hose from the filler pipe.

| 11. DISCONNECT NO. 3 FUEL HOSE |
Disconnect the fuel hose from the filler pipe.

| 12. DISCONNECT FUEL TANK TO FILLER PIPE HOSE |
Disconnect the hose from the filler pipe.

| 13. REMOVE FUEL SUB TANK SUB-ASSEMBLY |
Disconnect the floor No. 3 wire connector.

Using a clip remover, detach the 3 wire harness clamps.
Set a transmission jack underneath the fuel sub tank.
Remove the 2 bolts and disconnect the 2 fuel tank bands.

Remove the fuel sub tank.
| 14. REMOVE FLOOR NO. 3 WIRE |
Disconnect the sender gauge connector.

Using a clip remover, detach the wire harness clamp.
| 15. REMOVE FUEL SENDER GAUGE ASSEMBLY |
Remove the 5 screws and sender gauge.

- NOTICE:
- Be careful not to bend the arm of the fuel sender gauge.
Remove the gasket from the sender gauge.
| 16. REMOVE FUEL HOSE |
![]() ![]() |
| 17. REMOVE FUEL TANK EVAPORATION VENT TUBE SUB-ASSEMBLY |
Remove the 2 fuel tank evaporation vent tubes.

| 18. REMOVE FUEL AND EVAPORATION VENT TUBE SUB-ASSEMBLY |
Remove the 6 bolts and fuel and evaporation vent tube.

Remove the gasket from the fuel and evaporation vent tube.
| 19. REMOVE FUEL TANK BREATHER HOSE |
Remove the breather hose from the fuel sub tank.

| 20. REMOVE NO. 3 FUEL HOSE |
Remove the fuel hose from the fuel sub tank.

| 21. REMOVE FUEL TANK TO FILLER PIPE HOSE |
Remove the hose from the fuel sub tank.



